OSO NANO N
Point of use water heater with full capacity in 8 minutes
NANO — N is ideal as a point of use unit where central heating is located at a distance. NANO fits easily under sink, and can be installed both vertically and horizontally. Capacity is 12 L 40°C hot water — more than adequate for hand wash, kitchenettes or similar demands. NANO comes standard with 3 kW ultra-grade INCOTEC immersion heater. The unit is ready for use after just 10 minutes, with a capaity of 75 L 40°C hot water / hour. NANO can be fitted anywhere due to its modest size, and wall bracket as well as safety valve is included.
WHY CHOOSE NANO?
• Perfect for point-of-use installations or limited hot water needs
• 75 L 40°C / hour, fully charged after only 10 minutes
• 5 year warranty on the stainless steel pressure tank
• Supported by BIM, see more by clicking BIM here
|Specifications||Unit||N 5 - 3 kW / 1 × 230 V|
|Product name||N 5 - 3 kW / 1 × 230 V|
|Placement||Floor or wall|
|Diameter — ⌀||mm||L 250 × B 250|
|Height — H||mm||500|
|Packaging||mm||550 × 255 × 255|
|Technical / ErP information|
|Capacity 40°C||L||Not applicable|
|Thermostat set point||°C||65|
|Heat loss |
|Heat loss / 24 hrs - EN 12897||kWh/day||Not applicable|
|AEC (energy consumption)||kW /year||Not applicable|
|Energy efficiency||%||Not applicable|
|Tapping profile||3XS–XXL||Not applicable|
|Primary Heating Power||kW||Not applicable|
|Heat-up time ΔT 55°C Coil||Mins||Not applicable|
|Heat-up time ΔT 55°C upper element||Mins||Not applicable|
|Heat-up time ΔT 55°C lower element||Mins||Not applicable|
|Recovery time ΔT 55°C coil 70%||Mins||Not applicable|
|Recovery time ΔT 55°C upper element 70%||Mins||Not applicable|
|Recovery time ΔT 55°C lower element 70%||Mins||Not applicable|
MORE HOT WATER
Substantially higher temperature (70°C+), highly efficient mixing valve (no scolding), minimal heat loss and optimal design features gives up to 20 % more hot water and class leading capacity.
The use of NANOPUR™ with insulation values far surpassing Pentane, often in combination with VACUUM panels, ensures minimum heat loss and class leading energy efficiency.
EVERLAST™ titanium alloyed stainless steel in combination with OSO’s unique ULTRAWELD™ system and state-of-the-art passivation process equals class leading corrosion resistance.
EVERLAST™ titanium alloyed, high tensile strength, stainless steel equals lower weight and efficient use of resources. OSO products are more than 40 % lighter than enameled products.
BUILT TO LAST
INCOTEC™ el. immersion heaters with ultra high-grade Incoloy 825 stainless, DZR brass, zinc-free soldering and carefully calculated surface loads results in maximum durability in hard water.